CLASS TD POWER AMPLIFIER DAP10-4 4 X 2100W @ 4 OHM
The DAP10.4 is a Class TD amplifier engineered to perform perfectly under all load conditions. The output maintains its flat frequency response even into complex loads, easily handling nominal impedances as low as 2Ω.
The audio quality, efficiency, and reliability meet and exceed that of even the very best Class AB designs.
Class TD amplifiers allow for greater power density while minimizing cooling requirements and providing zero interference with RF equipment. The DAP10.4 provides ultimate power and ultimate reliability for even the most demanding situations.
• Dual Circuit Breakers
• Class TD Circuitry for ultimate reliability and efficiency
• Balanced XLR Inputs per channel
• LED indicators for signal, clip, and protect for each channel;
• Parallel, Stereo, & Bridge Mode.
• Power & Level indicators.
• Precision Rotary level controls and power switch.
| Acoustic Specifications
|
CHANNELS: 4
FREQUENCY RESPONSE: ±0.5dB FROM 20Hz-20kHz TOTAL HARMONIC DISTORTION (THD): <0.1% @ 20Hz-20KHZ FOR 1W TOTAL HARMONIC DISTORTION (THD): <0.05% @ 1KHZ & 1DB BEFORE CLIPPING DAMPING FACTOR: GREATER THAN 800:1 SIGNAL TO NOISE RATIO: >108dBA INPUT IMPEDANCE: 20K OHM BALANCED TO GROUND INPUT SENSITIVITY: 0.77V-1.0V-1.44V SELECTABLE |
AMPLIFIER TYPE: CLASS TD
POWER OUTPUT PER CH. (@ 2Ω): 2500W POWER OUTPUT PER CH. (@ 4Ω): 2100W POWER OUTPUT PER CH. (@ 8Ω): 1100W POWER OUTPUT BRIDGED (@ 4Ω): 2 x 4100W POWER OUTPUT BRIDGED (@ 8Ω): 2 x 3000W
|
|
| Input / Output Section
|
INPUT CONNECTORS:
4 x XLR BALANCED |
OUTPUT CONNECTORS:
4 x SPEAKON |
|
| Controls | FRONT PANEL:
4 x ROTARY CHANNEL LEVEL POWER SWITCH
|
REAR PANEL:
INPUT SENSITIVITY SWITCH MODE SELECTOR SWITCH DUAL CIRCUIT BREAKERS
|
|
| Protections | COOLING:
INTERNAL HEAT SINKS DUAL VARIABLE SPEED FANS FUSES: YES SHORT CIRCUIT: YES OPEN / MISMATCHED LOADS: YES POWER SUPPLY OVERLOAD: YES
|
EXCESSIVE TEMPERATURE:
YES SUBSONIC PHENOMENA: YES ULTRA SONIC PHENOMENA: YES DC TRANSIENTS: YES SOFT STARTS: YES
|
|
| Power Requirement | OPERATING VOLTAGE:
115V/60HZ 220V/50HZ (AVAILABLE UPON REQUEST) |
POWER CONSUMPTION: —– | |
| Construction | CASE MATERIAL:
METAL HANDLES: TWO COLOR: BLACK |
RACKMOUNTING: 19″, 3UFEET:—— | |
| Standard Compliance | CE MARKING:
YES |
||
| Dimensions | WIDTH:
19 INCH / 482 mm DEPTH: 19.9 INCH / 505 mm HEIGHT: 5.2 INCH / 132 mm |
WEIGHT: 81.5 LB / 37 KG | |
